What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
11.06.2025 06:08

What does a fuse do?
2024–10–10[John johnson John Johnson ]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Does any other guys get turned on by dick pic makes you lick lips because you what to suck?
In schematic diagrams this is the symbol for a fuse:
The third is lightning and “how it gets conducted into a home.”
This is where this question deviates from being a 'generic' question, and becomes more specific.
Why does my girlfriend keep asking me if I love her?
A fuse is a non-resetable over current circuit protector.
This is where the MOV conducts again, and dissipated the energy.
eight
What are the best mattress options for a comfortable night's sleep in Pompano Beach?
This one hit behind the barn.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Kidney disease: 5 symptoms women should be careful about - Times of India
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is 'the assistant's answer'
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Tahini Is The High Protein Food You Can Eat Every Day—With Almost Everything - Vogue
He then asserts :
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Why did you choose not to join Mensa?
Edit 2024–10.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
[old diagram got deleted by accident]
These are simplified answers to the original question, and does not change anything I wrote above.
So, the voltage could go up to 500 volts, and the fuse will not open up.
But it can get overloaded, and no longer works.
It also is a device that limits the change in current flow.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
What baseball stories from the early days of the sport seem too bizarre to be true?
One
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
We finally may be able to rid the world of mosquitoes. But should we? - The Washington Post
There are two important concepts here.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
nine
Subway owner buys popular chicken chain in $1 billion deal - PennLive.com
He then describes Rainy Season and Lightning.
what exactly is a ‘surge’ protector?
There are three different concepts here that are getting confused.
Some men love anal sex more than vaginal sex. Why?
An AC voltage/ current source, and an ac inductive load.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
At one ohm, the resistor has a maximum of 1 watt power.
What is lightning?
These devices are installed between the “hot” and “neutral” and protective ground.
Upvotes:
He then describes the function of a fuse.
but I think this circuit , shows a few more pieces.
A circuit breaker is similar, but is resettable.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–14 [Omar Gharbi Omar Gharbi ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This device then solves the entire problem.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At least they know the answer if they wanted it.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
One is “what exactly is in a ‘surge protector’ ? ”
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–10–16 [ OO OLAOYE OYEBODE ]
First Sentence:
But… the neutral is now “floating” because of the 1 ohm resistance.
(Dc diagram shown, AC is similar).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
The bolt then partially travels down the line to your home.
I post the exact comment here.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Here is a simplified AC power diagram.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
so, what happens?
For this case there are devices called Metal oxide varistors (MOV).
Barnstars:
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
but this device (an Inductor) … impedes the rapid changes in the current.
the problem then depends on "how fast does the fuse operate?".
a photo is worth a thousand words.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The other is “what does a “fuse” do?”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
[image of Common-mode choke]